An in-ground pool is a kind of swimming pool that is built into the ground in such a way that its highest point is level with the surrounding lawn. It will be a more permanent addition to your backyard than an above-ground pool. Concrete, fibreglass, and vinyl are the most popular materials for building an in-ground pool, but there are other options as well. You need to think about the pros and disadvantages of each material for your pool thoroughly before making a final decision. In the following paragraphs, we’ll go over the pros and cons of each in-ground pool material, as well as the considerations you’ll need to make when settling on the best option for your lifestyle and yard.
Surface treatments for concrete that use plaster or aggregate
Most in-ground pools are made of concrete or plaster. When swimming pools were originally being installed in private homes, these were the materials of choice. Steel-reinforced concrete is a kind of concrete that is used to provide a protective exterior. The plastered exterior may absorb water without losing its structural integrity and can be replastered as needed to extend the life of the structure. This is all possible because concrete is both a long-lasting and porous material. In comparison to vinyl, for example, the upfront cost of concrete is greater; nonetheless, it is often considered the most cost-effective option since it can be maintained for a long time and, with good care, is unlikely to ever need to be replaced. 1 Despite this, concrete has a greater initial investment. Search by pool builders near me and get the best solutions there.
What happens is as follows
When a hole is excavated in the ground, rebar is used to frame the hole and line the bottom and the sides. The digging is now finished (steel rods). These may be shaped into almost any design, from squares and hearts to guitars, and they can even have features like steps and ramps added to them. Shotcrete or gunite, a combination of sand, concrete, and water, is sprayed on using a hose to produce a finish for the pool shell after the rebar has been set. Gunite and shotcrete are two names for the same thing. Plaster, a combination of cement and marble dust, is added to the concrete after it has dried. Plaster with coloured quartz added for aesthetic reasons. Plastering is a crucial step since it seals the pool and prevents water leaks.
Through this method, a contractor may figure out the exact measurements and shape of a concrete pool. The cost of a pool with modern curves shouldn’t often exceed that of a pool of the same size but with a more traditional, angular shape.
Coatings of either ceramic or natural stone on concrete
Concrete pools may also be the base upon which more trendy materials like tile or stone are laid. Thinset mortar is applied to the pool’s surface after the concrete foundation has been poured and allowed to cure (in a sequence of operations similar to those described above). This prepares the surface for the installation of tile or stone. At least 24 hours should elapse before the tile is finished with polymer-fortified grout to survive the constant dampness and pool chemicals.
